Philips 40PFL4706 ユーザーガイド

Network update

You can update the software by connecting the unit to the internet.

steps

1 to 2 in ‘Connection test’ on page 29.

Press

MENU on the remote control and then use

Î/ï/ Í /Æ to

select [Setup] > [Software] > [Software update] > [Network].

Use

Í /Æ to select [Yes], then press OK.

• This unit will then start checking for the latest fi rmware

version.

Confi rmation message will appear. Use

Í /Æ to select [Yes], then

press OK.
•  The unit will start downloading the latest fi rmware version.
•  The unit will start updating the fi rmware version.
•  It may take a while to complete the updating.

When the software update is complete, press POWER

. at the

side of the TV to make sure the unit goes to standby mode.

Switch on the TV.

The TV starts up with the new software.

Note

•

In order to update software via the internet, you must connect the unit to the internet
and set up necessary settings.

•

For the network connection, refer to ‘Connecting the TV to the internet using an
Ethernet cable’ or ‘Connecting the TV to the internet using a wireless LAN’ on page 40.

•

For the network setup, refer to ‘Network’ on page 29.

•

Please do not unplug the AC power cord or Ethernet cable while executing the
‘Network update’.

•

All settings will remain the same even if you update the software version.

•

The version of Netfl ix will also be updated if newer version of Netfl ix is available when
updating the fi rmware.