Lexmark e360dtn ユーザーズマニュアル
C
HANGE
THE
P
AGE
P
ROTECT
SETTING
TO
O
FF
1
From the printer control panel, press
.
2
Press the arrow buttons until Settings appears, and then press
.
3
Press the arrow buttons until General Settings appears, and then press
.
4
Press the arrow buttons until Print Recovery appears, and then press
.
5
Press the arrow buttons until Page Protect appears, and then press
.
6
Press the arrow buttons until Off appears, and then press
.
Job prints from the wrong tray or on the wrong paper
C
HECK
THE
P
APER
T
YPE
SETTING
Make sure the Paper Type setting matches the paper loaded in the tray.
Incorrect characters print
Make sure the printer is not in Hex Trace mode. If Ready Hex appears on the display, you must exit Hex Trace mode
before you can print your job. Turn the printer off and back on to exit Hex Trace mode.
before you can print your job. Turn the printer off and back on to exit Hex Trace mode.
Tray linking does not work
L
OAD
THE
SAME
SIZE
AND
TYPE
OF
PAPER
IN
EACH
TRAY
1
Load the same size and type of paper in each tray.
2
Move the paper guides to the correct positions for the paper size loaded in each tray.
M
AKE
SURE
THE
P
APER
S
IZE
AND
P
APER
T
YPE
SETTINGS
ARE
THE
SAME
FOR
EACH
TRAY
1
Print a menu settings page and compare the settings for each tray.
2
If necessary, adjust the settings from the Paper Size/Type menu.
Note: None of the paper sources, trays, or feeders automatically sense the paper size. You must set the size from
the Paper Size/Type menu on the printer control panel or from the Embedded Web Server.
the Paper Size/Type menu on the printer control panel or from the Embedded Web Server.
Large jobs do not collate
These are possible solutions. Try one or more of the following:
M
AKE
SURE
C
OLLATE
IS
SET
TO
O
N
From Print Properties or the printer control panel Finishing menu, set Collate to On.
Note: Setting Collate to Off in the software overrides the setting in the Finishing menu.
Troubleshooting
112