Bizfon 680 オーナーマニュアル
Bizfon Owner’s Guide
61
Appendix B
Startup/Test
Button
Startup/Test
Button
Using the Star-
tup/Test Button
tup/Test Button
After connecting your telephone lines and
telephones, you can use the Startup/Test but-
ton to confirm that your Bizfon 680 is prop-
erly set up.
telephones, you can use the Startup/Test but-
ton to confirm that your Bizfon 680 is prop-
erly set up.
1. Press the blue Startup/Test button in the
center of the Bizfon 680. You will hear:
“Welcome to the Bizfon diagnostics. Note
that during the diagnostics, the Bizfon may
not be used for calls. To run diagnostics on
incoming telephone lines and telephones,
press the button again.”
that during the diagnostics, the Bizfon may
not be used for calls. To run diagnostics on
incoming telephone lines and telephones,
press the button again.”
CAUTION!
Any calls in progress on extensions or CO
lines will be disconnected while diagnostics
are running.
lines will be disconnected while diagnostics
are running.
2. Push the button again. You will hear:
“Now running the incoming telephone lines
test. The LEDs for each incoming line flash if
a plugged-in line is detected. Each line is
retested every few seconds. To end this test
and continue with the voice quality test,
press the button again.”
test. The LEDs for each incoming line flash if
a plugged-in line is detected. Each line is
retested every few seconds. To end this test
and continue with the voice quality test,
press the button again.”
While the diagnostics run, you should verify
that all incoming lines have blinking LEDs,
which indicate that they are functioning cor-
rectly.
that all incoming lines have blinking LEDs,
which indicate that they are functioning cor-
rectly.