Hitachi c12fdh compound miter saw ユーザーガイド

English

17mm box wrench

10mm bolt

Washer (B)

Saw blade

10mm bolt

Washer (B)

Washer (A)

21/32” (17mm)

1” (25.4mm)

Fig. 44-c

Fig. 44-d

(7) Press in the spindle lock and tighten the 10mm bolt by turning it to the left by standard accessorie’s

wrench (17mm box wrench) as indicated in Fig. 44-c.

CAUTION:

* Confirm that the spindle lock has returned to the retract position after installing or

removing the saw blade.

* Tighten the 10mm bolt so it does not come loose during operation.

Confirm the 10mm bolt has been properly tightened before the power tool is started.

2. Dismounting the saw blade

Dismount the saw blade by reversing the mounting procedures described in paragraph 1 above.
The saw blade can easily be removed after lifting the safety cover.

CAUTION:

Never attempt to install saw blades larger than 12” (305mm) in diameter.
Always install saw blades that are 12” (305mm) in diameter or less.

MAINTENANCE AND INSPECTION

WARNING:

To avoid an accident or personal injury, always confirm that the trigger switch is turned
OFF and the power plug has been disconnected from the receptacle before performing
any maintenance or inspection of this tool.

1. Inspecting the saw blade

Always replace the saw blade immediately upon the first sign of deterioration or damage.
A damaged saw blade can cause personal injury and a worn saw blade can cause ineffective operation
and possible overload to the motor.

CAUTION:

Never use a dull saw blade. When a saw blade is dull, its resistance to the hand
pressure applied by the tool handle tends to increase, making it unsafe to operate
the power tool.

2. Inspecting the lever

If the M8 hexagonal head bolts (2) are loose, align the sides of the fence and saw blade with the steel
square. After adjusting the saw blade and fence to a ninety-degree angle, tighten the lever securing
hexagonal head bolts (2).

Lever

Hex. head bolt (2)

Saw blade

Fence

Steel square

Fig. 45-a

Fig. 45-b