Frigidaire feq1442es0 クイック設定ガイド

High is recommended for sturdy fabrics.

Medium is recommended for wrinkle free, perma-
nent press and lightweight fabrics.

Low is recommended for delicate fabrics.

No Heat should only be used with a Timed Dry
setting to dry items containing feathers, down, foam
rubber, plastics or  rubber-like materials;  to freshen
clothing, pillows or blankets; or to dust draperies.

PN 134420600C  (0412)

Select Damp Dry for items you wish to partially
dry before hanging or ironing.

Note:  To prevent over-drying, not every dryness
level is available with every cycle.

To change the dryness level, press DRYNESS un-
til the desired selection is made.

Select Normal

for most loads.

Occasionally a load may seem too damp or over-
dried at the end of the cycle. To increase drying
time for similar loads in the future, select More
Dry. For loads requiring less drying time, select
Less Dry.

To select an option, press OPTIONS until the indi-
cator for the desired option flashes and press SE-
LECT.  If an option is not available for a cycle, the
indicator will not light.  Follow the same steps to
delete an option.

The Cycle Signal will sound at the end of the cycle
and  periodically during  Press Saver.

Select  Press Saver if the dried load might not be
removed promptly at the end of the cycle.  The dry
load will continue  tumbling without heat for 30 min-
utes to help reduce wrinkling. When the Cycle
Signal is selected, a beep will be heard periodi-
cally.  The load may be removed any time during
Press Saver.

To avoid having someone accidentally start or stop
the dryer, press OPTIONS and SELECT at the same
time until the Control 

 (Control Lock) indicator is

lighted.  To remove the control lock, press OPTIONS
and SELECT again.

The following indicators may be lighted during the
cycle:
•    Drying

•    Cool Down

•    Press Saver

•    Clean Lint Filter
•    Control   (Control Lock)

Select this Auto Dry cycle for knits and delicate
items.

Select this cycle to quickly dry a small load made
up of just a few items.  It provides approximately
20 minutes of tumbling followed by a 10-minute cool
down period.

Select Touch Up to help remove wrinkles from clean
and dry items that were not taken from the dryer at
the end of the cycle, have been stored in crowded
closets or drawers, or unpacked from luggage fol-
lowing a trip. It provides approximately 10 minutes
of tumbling followed by a 5-minute cool down
period.

To manually select the drying time for any load,
turn the knob to a numbered setting.  Drying times
from 15 to 90 minutes are available in 15-minute
increments.  You will not be able to select a cycle
or dryness level.  Timed Dry is recommended when
using the No Heat option.
Note:  To change cycles, press PAUSE/CANCEL
twice.

For best results, follow the fabric care label
instructions on items to be dried.

A suitable combination of dryness level and options
will automatically be displayed for each cycle.  The
settings can be changed before the cycle is started.
Those adjustments will automatically be remem-
bered each time that cycle is selected.  If a dry-
ness level or option is not recommened for a cycle,
the indicator will not light.  See the “Dryer Settings
Chart” for more details.

If changes are attempted after the cycle starts, the
status lights will blink and the signal will beep 3
times.  The cycle must be paused before the set-
tings can be changed.

Note: Using No Heat in any Auto Dry cycle will
result in long drying times and /or wet loads at the
end of the cycle.

 

 To avoid fire hazard, do not use heat

to dry items containing feathers or down, foam rub-
ber, plastics, or similarly textured, rubber-like ma-
terials. Use the No Heat setting only.