Frigidaire plgf659eca データシート
2
F10
Control has sensed a potential runaway
oven condition. Control may have shorted
relay, RTD sensor probe may have gone
bad.
oven condition. Control may have shorted
relay, RTD sensor probe may have gone
bad.
F11
Shorted keypad.
F13
Control's internal checksum may have
become corrupted.
become corrupted.
F14
Misconnected flat cables.
F30
Open RTD sensor probe/ wiring problem.
Note: EOC may initially display an "F1",
thinking a runaway condition exists.
Note: EOC may initially display an "F1",
thinking a runaway condition exists.
F31
Shorted RTD sensor probe / wiring problem.
Note: "F3" is displayed when oven is in
active mode or an attempt to enter an
active mode is made.
Note: "F3" is displayed when oven is in
active mode or an attempt to enter an
active mode is made.
F90
Door motor mechanism failure.
to
F94
F94
Likely Failure Condition/Cause
Suggested Corrective Action
1. Check RTD sensor probe and replace if necessary. If oven is
overheating, disconnect power. If oven continues to overheat
when the power is reapplied, replace EOC. Severe overheating may
require the entire oven to be replaced, should damage be extensive.
when the power is reapplied, replace EOC. Severe overheating may
require the entire oven to be replaced, should damage be extensive.
2. Press CLEAR key.
3. Disconnect power, wait 30 seconds and reapply power. If fault
3. Disconnect power, wait 30 seconds and reapply power. If fault
returns upon power-up, replace EOC.
4. Disconnect power; verify flat cable connections (P12 or P13).
1. Press CLEAR key.
2. Check wiring in probe circuit for possible open condition. Check
2. Check wiring in probe circuit for possible open condition. Check
RTD resistance at room temperature (compare to probe resistance
chart). If resistance does not match the chart, replace the RTD
sensor probe.
chart). If resistance does not match the chart, replace the RTD
sensor probe.
3. Let the oven cool down and restart the function
1. Press CLEAR key.
2. If CLEAR key does not eliminate problem, turn off power for 30
2. If CLEAR key does not eliminate problem, turn off power for 30
seconds, then turn on power.
3. Check wiring of Lock Motor, and Lock Switch and Door Switch
circuits.
4. Unplug P5, apply power (L1) directly to the Lock Motor, if the motor
does not rotate, replace Lock Motor Assembly. Plug P5.
5. Check Lock Switch A for proper operation (do they open and close,
check with ohmmeter). The Lock Motor may be powered as in above
step to open and close Lock Switch. If the Lock Switch is defective,
replace Motor Lock Assembly.
step to open and close Lock Switch. If the Lock Switch is defective,
replace Motor Lock Assembly.
6. If all above steps fail to correct situation, replace control.
ELECTRONIC OVEN CONTROL (EOC) FAULT CODE DESCRIPTIONS AND RTD SCALE
ELECTRONIC OVEN CONTROL
It is normal to see a temperature overshoot in the
first rise of all modes when you monitor the temperature.
first rise of all modes when you monitor the temperature.
FIRST RISE
OVEN CALIBRATION
Set the electronic oven control for normal baking at 350°F/176°C. Obtain an average oven temperature after a
minimum of 5 cycles. Press Cancel to end bake mode.
minimum of 5 cycles. Press Cancel to end bake mode.
Note: Changing calibration affects all the cooking modes but not the clean mode.
set point
First rise overshoot
T
°
t (sec)