Microtek d3 ユーザーガイド

Federal Communications Commission Interference

Statement
This equipment (MDSC-TKS3CMOS or ES-330) has

been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC

rules. These limits are designed to provide reasonable

protection against harmful interference in a residential

installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause

harmful interference to radio communications.

However, there is no guarantee that interference will

not occur in a particular installation. If this equipment

does cause harmful interference to radio or television

reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following

measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and

receiver.

Connect the equipment into an outlet on a circuit

different from that to which the receiver is

connected.

Consult the dealer or an experienced radio/TV

technician for help.

Notes: A shielded USB interface cable with ferrite core

installed on the camera connector end must be used

with this equipment.
Caution: Changes or modifications not expressly

approved by the manufacturer responsible for

compliance could void the user's authority to operate

the equipment.
This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1)

This device may not cause harmful interference, and

(2) this device must accept any interference received,

including interference that may cause undesired

operation.
Responsible Party:

Loi Han

Microtek Lab, Inc.

16941 Keegan Avenue

Carson, CA 90746

USA

Phone: 310-687-5800

Fax: 310-687-5950

Tested to Comply
With FCC Standards

FOR HOME OR OFFICE USE