Microtek 1000xl ユーザーガイド

ArtixScan 2500 Installation and Operation Manual     27

The correct positioning of the reflective color target on
the ArtixScan 2500 is critical. The lens of the scanner is
only 4 inches wide, and unless the target is positioned
exactly as shown below, the scanner may miss out on
scanning the calibration area of the 5"x7" target. A slight
deviation from the correct positioning, for example, may
mislead the scanner into reading the non-calibration area
instead.

To position the reflective color target correctly on the
upper scan bed, follow the steps below:

1.

Flip the target so that you are looking at the under-
side or reverse side of the target. Hold up the target
against a light source, and trace the top border on the
flip side of the target with a pen (see graphic below).

5

2

4

5

0

0

5

10

B5

A4

Trace this border line on the flipped
side of the target. When positioning,
this border line must align and on
the same track with the center of top
ruler

HIGH RESOLUTION

Top ruler center

2.

Place the target on the glass surface of the scanner
bed, making sure that you flip the target so that the
image of the lady lies directly across the scanner’s
top ruler (check with graphic below for correct
orientation of target). Rest the edge of the target
against the scanner’s top ruler.

3.

Adjust the position of the target so that the right side
of the borderline (near the top of the lady’s head) is
aligned exactly with the center of the top ruler
(marked “0”).