Microtek c997sd ユーザーガイド

If there is no display on the LCD, please perform the following steps:

1. Make sure that the power indicator on the LCD Monitor is lit,

all connections are secure, and the system is running on the

correct timing.  Refer to the Addendum for information on

timing.

2. Turn off the LCD Monitor and then turn it back on again.

Press the upper Function Control button (refer to Chapter 2)

once and then press either the upper or lower Adjustment

Control button several times.  If there is still no display, press

the other Adjustment Control button several times.

3. If step 2 does not work, connect your PC system to another

external CRT.  If your PC System functions properly with a

CRT Monitor but it does not function with the LCD Monitor,

and the LCD Monitor’s power LED is blinking, the output

timing of the PC’s VGA card may be out of the LCD’s

synchronous range.  Please change to an alternate mode

listed in Addendum or replace the VGA card and repeat steps

1 and 2.

4. If the PC does not function with the CRT monitor as well,

check the BIOS to see if there is a dual scan setting under the

display mode item.  Set the BIOS display mode to 

Dual Scan

or 

CRT and try again.  If there is still no display, then there

may be a problem with your system.  Contact technical

support.

5. If the power LED is not lit, check to see if the AC power

connector is securely connected.  Verify that the AC adapter
LED is lit.  If the AC adapter LED is not lit, please contact your
dealer for assistance.

Ｃ９９７ＳＤ　Ｅｎｇｌｉｓｈ．ｐ６５

03-3-26, 13:41

24