SATO MB410i ユーザーガイド
Unit 4: Operation and Configuration
MB400i/MB410i Operator Manual
PN 9001190C
Page 4-25
ADJUSTING PRINTING FOR LINERLESS LABELS
When printing on a continuous label roll (linerless label without perforation), if you tear off a label
at the wrong place, proceed as follows.
at the wrong place, proceed as follows.
Figure 4-21, Location of PRINT Button and FEED Button
1. Interrupt printing on the computer, or press the PRINT key in the ONLINE state to take the
printer OFFLINE. (STATUS LED goes off).
Figure 4-22, Pulling the Printed Label Toward You
2. Press the FEED button to feed a label (assuming that I-mark sensor is being used). When the
feeding stops, tear off the label correctly by pulling the label in the direction of the arrow
shown in Figure 4-22. The label is now aligned properly for printing to resume.
shown in Figure 4-22. The label is now aligned properly for printing to resume.
3. Press the PRINT button to return to the online state (STATUS LED lights green). You can now
resume the print job.
12345
67
ABCDE
F G
abcdefg
1
AB C
abcd
FEED button
PRINT button
1234567
AB C
DE FG
abcd
efg
1234567
AB
C DE
F G
abcd
efg