BG 210i ユーザーガイド
© BG Corp 2005
12
Unpacking Radia 520i / 420i
1. Lay the shipping box down on the floor, ensuring that you have adequate
space to lay the loudspeaker down after removing it from the shipping
box. Note: if your floor is not carpeted, lay a blanket or other suitable soft
fabric on the floor to prevent damage to your loudspeakers.
box. Note: if your floor is not carpeted, lay a blanket or other suitable soft
fabric on the floor to prevent damage to your loudspeakers.
2. Rotate the box so that the white product label affixed at the factory is on
top and facing up.
3. Pull the top flaps of the shipping box up, taking care not to cut yourself
on the staples used to close the box. Open the other cardboard flaps
to expose the loudspeaker still cradled in it’s protective foam and inside
a protective plastic bag. Remove the foam pieces over the top of the
loudspeaker. DO NOT open box ends.
to expose the loudspeaker still cradled in it’s protective foam and inside
a protective plastic bag. Remove the foam pieces over the top of the
loudspeaker. DO NOT open box ends.
4. Remove the loudspeaker by lifting it straight up and out of the box. Due
to their weight, we recommend that two people work together to remove
Models 520i and 420i.
Models 520i and 420i.
Assembly Instructions for 520i / 420i
Loudspeaker
Loudspeaker
1. Prepare the following tools: a Phillips screwdriver and an Allen (hex)
wrench (located in the packing box).
2. Carefully remove the loudspeaker from the packing box as above. Place it
on a stable surface with a soft cushioning cover (use chairs, a small table
covered with foam or a sofa at least one foot above the floor). Remove
plastic protective film from the glossy part of the base. With the front of
the grill facing up or to the side (Fig. 1) make sure the loudspeaker is
in a stable position. To facilitate the assembly procedure, position the
loudspeaker so the high gloss base is free or has its own support.
covered with foam or a sofa at least one foot above the floor). Remove
plastic protective film from the glossy part of the base. With the front of
the grill facing up or to the side (Fig. 1) make sure the loudspeaker is
in a stable position. To facilitate the assembly procedure, position the
loudspeaker so the high gloss base is free or has its own support.
Special Assembly Instructions