Star Micronics DP8340R ユーザーガイド
– 35 –
TYPE
ONLY
D
Figure 8-5. D-Sub 25 Pin Connector
8-6.
Interface Connections
For interface connections, refer to the instructions for interface of the host
computer. The following gives one basic example of connections.
computer. The following gives one basic example of connections.
Figure 8-6. Interface Connections
with D-Sub 25 Pin Connector to IBM PC
*1 Error Condition Alarm Mode
If an error condition is detected during operation, the printer will stop
printing and cause the FAULT signal to go MARK. All solenoides & motors
will be de-energized. It is necessary to turn the printer power off and on again
in order to recover from the alarm mode.
This printer can detect the following error coditions:
If an error condition is detected during operation, the printer will stop
printing and cause the FAULT signal to go MARK. All solenoides & motors
will be de-energized. It is necessary to turn the printer power off and on again
in order to recover from the alarm mode.
This printer can detect the following error coditions:
a. Motor Lock
b. Defective timing detector
c. Micro-proccessor out of program sequence
b. Defective timing detector
c. Micro-proccessor out of program sequence