Panamax BEZ5400-EXS プリント
MAX
®
5400-EX REAR PANEL FEATURES
Main Circuit
Breaker
Breaker
Automatically opens
when the current
load is greater than
15 Amps.
when the current
load is greater than
15 Amps.
Ground Lug
Provides a common grounding
point for equipment with separate
ground leads.
point for equipment with separate
ground leads.
Main Power
Must be plugged
into a properly
wired & grounded
3-wire outlet
into a properly
wired & grounded
3-wire outlet
Outlet Banks 1 & 2
Two always on outlets per bank. Power will only be
turned off under a fault condition. (See specifications
for over-voltage and under-voltage thresholds)
Power for each bank is cleaned by a four-stage bal-
anced Pi filter. Banks 1 and 2 are noise isolated from
each other as well as all other outlet banks.
turned off under a fault condition. (See specifications
for over-voltage and under-voltage thresholds)
Power for each bank is cleaned by a four-stage bal-
anced Pi filter. Banks 1 and 2 are noise isolated from
each other as well as all other outlet banks.
Outlet Banks 3 & 4
Two switched outlets per bank. ON/OFF status is controlled by the
front panel Power Button or the DC Trigger input. They will turn on
immediately and turn off after 10 seconds. EMI/RFI noise filtration
is provided by the four stage balanced Pi filter. Banks 3 and 4 are
noise isolated from each other as well as all other outlet banks
front panel Power Button or the DC Trigger input. They will turn on
immediately and turn off after 10 seconds. EMI/RFI noise filtration
is provided by the four stage balanced Pi filter. Banks 3 and 4 are
noise isolated from each other as well as all other outlet banks
.
Outlet Bank 5
Two switched, high current outlets controlled by
the front panel Power Button or the DC Trigger
input. Bank 5 has a 5 second turn on delay and
turns off immediately. The High Current outlets
provide power from a low impedance noise filtra-
tion circuit that does not limit the current to your
equipment. Its output is noise isolated from all of
the other outlet banks.
the front panel Power Button or the DC Trigger
input. Bank 5 has a 5 second turn on delay and
turns off immediately. The High Current outlets
provide power from a low impedance noise filtra-
tion circuit that does not limit the current to your
equipment. Its output is noise isolated from all of
the other outlet banks.
Voltage Sense
Trigger Input
Trigger Input
3.5mm (1/8”) Mini-Plug jack.
Connect to a remote trigger
device that uses a DC output
to trigger a startup/shutdown
sequence. This bypasses the
front panel power switch.
Connect to a remote trigger
device that uses a DC output
to trigger a startup/shutdown
sequence. This bypasses the
front panel power switch.
Voltage Sense
Trigger Output
Trigger Output
3.5mm (1/8”) Mini-Plug jack.
Connecting a trigger wire to the
Voltage Sense Output jack will
allow the input signal to pass
through the MAX® 5400-EX to
control the startup/shutdown of
an additional device.
Connecting a trigger wire to the
Voltage Sense Output jack will
allow the input signal to pass
through the MAX® 5400-EX to
control the startup/shutdown of
an additional device.
High Current Outlets
Delay Switch For
Outlet Bank 5
Delay Switch For
Outlet Bank 5
Allows the outlet bank to be set
as “Always ON” or with a 5
second turn-on delay
as “Always ON” or with a 5
second turn-on delay
Switched Outlets Delay Switch For Outlet Banks 3 & 4
Allows the outlet banks to be set as “Always ON” or with a 10 second turn-off delay
LAN Jacks
Protection circuits
for 10/100 baseT
Ethernet lines.
for 10/100 baseT
Ethernet lines.
Phone Jacks
Protection circuits for stan-
dard telephone or pay-per-
view lines. Phone circuit is
auto-resetting.
dard telephone or pay-per-
view lines. Phone circuit is
auto-resetting.
Satellite TV
Coax Jacks
Coax Jacks
Bidirectional protection
circuit optimized for
satellite TV signal lines.
circuit optimized for
satellite TV signal lines.
Cable TV Coax Jacks
Bidirectional protection circuit opti-
mized for cable TV, off-air antennas
and cable modem signal lines.
mized for cable TV, off-air antennas
and cable modem signal lines.
MAX
®
5400-EX SPECIFICATIONS
AC Power
Line Voltage:____________________________________________________120V, 60Hz
Total Current Capacity:
Total Current Capacity:
_______________________________________________15 A
UL1449 Suppression Rating:____________________________________________330V
Protection Modes:______________________________________________L-N, L-G, N-G
Initial Clamping Level:_________________________________________________200V
Energy Dissipation:______________________________________________1815 Joules
Peak Impulse Current:___________________________________________73,000 Amps
Catastrophic Surge Circuit:_______________________________________________Yes
Thermal Fusing:_______________________________________________________Yes
Over-voltage shutoff:__________________________________________142 VAC ±5 VAC
Under-voltage shutoff:_________________________________________90 VAC ± 2 VAC
EMI/RFI Noise Filtration
Protection Modes:______________________________________________L-N, L-G, N-G
Initial Clamping Level:_________________________________________________200V
Energy Dissipation:______________________________________________1815 Joules
Peak Impulse Current:___________________________________________73,000 Amps
Catastrophic Surge Circuit:_______________________________________________Yes
Thermal Fusing:_______________________________________________________Yes
Over-voltage shutoff:__________________________________________142 VAC ±5 VAC
Under-voltage shutoff:_________________________________________90 VAC ± 2 VAC
EMI/RFI Noise Filtration
Banks 1 - 4:________________________________________100 db, 100 KHz – 2 MHz
Bank 5, High Current Outlets:____________________________60 db, 100 KHz – 2 MHz
Common Mode (all banks)______________________________60 db, 100 KHz - 2 MHz
DC Trigger Input
Jacks:_______________________________________________3.5mm (1/8”) mini-plug
Voltage and Polarity:___________________________________3 - 24V DC, bidirectional
Current Requirement:_________________________________4.6 mA @3V, 58 mA @24V
Voltage and Polarity:___________________________________3 - 24V DC, bidirectional
Current Requirement:_________________________________4.6 mA @3V, 58 mA @24V
DC Trigger Output
Voltage:____________________________________________________________<15V
Current:_________________________________________________________<500 mA
Short-circuit protection:_________________________________________________Yes
Delay on output:_________________________________________________10 seconds
Current:_________________________________________________________<500 mA
Short-circuit protection:_________________________________________________Yes
Delay on output:_________________________________________________10 seconds
LAN Circuit
Clamping Level:____________________________________________________8V ± 2V
Jacks:_____________________________________________________________RJ-45
Wires Protected:_______________________________________4-Wires, Pins 1, 2, 3 & 6
Jacks:_____________________________________________________________RJ-45
Wires Protected:_______________________________________4-Wires, Pins 1, 2, 3 & 6
Telephone Circuit
Fuseless/Auto-resetting:_________________________________________________Yes
Clamping Level:______________________________________________________260V
Capacitance:__________________________________________________30pf (approx.)
Suppression Modes:____________________________________Metallic & Longitudinal
Jacks:_____________________________________________________________RJ-11
Wires Protected:___________________________________________2-Wire, Pins 4 & 5
Clamping Level:______________________________________________________260V
Capacitance:__________________________________________________30pf (approx.)
Suppression Modes:____________________________________Metallic & Longitudinal
Jacks:_____________________________________________________________RJ-11
Wires Protected:___________________________________________2-Wire, Pins 4 & 5
Satellite TV Circuit
Bidirectional:__________________________________________________________Yes
Shielded:_____________________________________________________________Yes
Clamping Level:_______________________________________________________27V
Attenuation:______________________________________< 1db from 950MHz-2.05GHz
Shielded:_____________________________________________________________Yes
Clamping Level:_______________________________________________________27V
Attenuation:______________________________________< 1db from 950MHz-2.05GHz
< 2.4db @ 2.2GHz
Connections:__________________________________________Female “F”, Gold Plated
Cable TV Circuit
Bidirectional:__________________________________________________________Yes
Shielded:_____________________________________________________________Yes
Clamping Level:_______________________________________________________1.4V
Attenuation:________________________________________< 1db from 5MHz- 950MHz
Connections:__________________________________________Female “F”, Gold Plated
Shielded:_____________________________________________________________Yes
Clamping Level:_______________________________________________________1.4V
Attenuation:________________________________________< 1db from 5MHz- 950MHz
Connections:__________________________________________Female “F”, Gold Plated
Specifications subject to change due to product upgrades and improvements.
MODEL M5400-EX UNIT CARTON
MASTER CARTON
Dimensions
Weight
Dimensions
Weight UPC Qty Dimensions Weight
UPC
17" x 12.75" x 3.5"
19 lbs
23.75" x 19.25" x 9.5" 22.5 Lbs 0 50616 00787 0 1 Same as 22.5 Lbs 5 00 50616 00787 5
4.1" H with feet
Unit Carton
UPC’s, QUANTITIES, WEIGHTS & MEASUREMENTS FOR ORDERING & SHIPPING
OPTIONAL SILVER BEZEL
SILVER BEZEL
PRODUCT
UNIT CARTON
MASTER CARTON
Model # Dimensions
Weight Dimensions Weight
UPC
Qty Dimensions
Weight
UPC
BEZ5400-EXS 17" W x 0.625" D x 3.5" H 14 Oz 18" x 4" x 1" 17.5 Oz 0 50616 00793 1 N/A N/A N/A N/A
© 2005 Panamax. Panamax, MAX and the Panamax logo are registered US trademarks of Panamax. Protect or Disconnect and AVM are trademarks of Panamax. SIDACtor is a registered US trademark of Teccor Electronics, Inc.
1690 Corporate Circle, Petaluma, CA 94954
•
800-472-5555 or 707-283-5900
•
Fax - 707-283-5901
•
www.panamax.com
The Power Specialists Since 1975
®