Fujitsu S26361-F2735-L130 ユーザーズマニュアル
Product Facts
⏐ Issue: March 25, 2008 ⏐ Product: PRIMERGY rack systems Design guide
Page 83 / 89
10.3.3 Notes on transport
Detaching from the wooden pallet
•
The unit is seated on the pallet and is secured with 6 metal clamps, which must be unscrewed from
the pallet.
the pallet.
•
To remove the screws you need a Phillips screwdriver.
•
Once the packaging foil has been removed, the unit must be slid off the pallet as shown above.
Transportation and storage
•
The following mechanical and climatic environmental conditions according to EN 60721-3-1 and -3-2
must be observed:
must be observed:
─
Storage:
Product class 1M3 / 1K2 1S2
─
Transport: Product class 2M2 / 2K2 2S1
•
Attention: When transporting the unit, make sure it does not tilt more than 30°.
•
The unit must remain in its original packaging until it reaches the installation location.
Safety instructions
Before components are pulled out or started up, the anti-tilt plate must be installed.
For further important notes on the rack see the Technical Manual “Rack System”, chapter 2. You will find
the manual in the accessory pack inside the rack.
the manual in the accessory pack inside the rack.