KitchenAid 24" Stainless Steel Beverage Center with SatinGlide® Metal-Front Racks 使用とお手入れ

INSTALLATION REQUIREMENTS

Tools

Gather the required tool before starting installation. 

Location Requirements

To ensure proper ventilation for your beverage center, allow for a 

¹/₄" (6.35 mm) space on each side and at the top. When installing 
your beverage center next to a fixed wall, leave 2

¹⁄₂" (6.35 cm) 

minimum clearance on the hinge side to allow for the door to 
swing open.

NOTE: It is recommended that you do not install the beverage 
center near an oven, radiator, or other heat source. Do not install 
in a location where the temperature will fall below 55°F (13°C). For 
best performance, do not install the beverage center behind a 
cabinet door or block the base grille. 

■

Height dimensions are shown with the leveling legs extended 
to the minimum height.

NOTE: When leveling legs are fully extended, add 

⁵⁄₈" (15 mm) 

to the height dimensions.

■

If the floor of the opening is not level with the kitchen floor, 
shim the opening to make it level with the kitchen floor.

Electrical Requirements

Before you move your beverage center into its final location, 

 

it is important to make sure you have the proper electrical 
connection.

A 115 volt, 60 Hz., AC only, 15- or 20-amp fused, grounded 
electrical supply is required. It is recommended that a separate 
circuit serving only your beverage center be provided. Use an 
outlet that cannot be turned off by a switch. Do not use an 

 

extension cord.

NOTE: Before performing any type of installation, cleaning, or 
removing a light bulb, unplug beverage center or disconnect 
power.

■

Phillips screwdriver

³⁄₄

A

B