KitchenAid KRFC302EBS 使用とお手入れ

Remove and Replace Handle Medallions 

(optional)

The handles for your model have red medallions on the ends. 
Replacement medallions are available for purchase. See 
“Accessories” to order. 

1. Using a 

¹⁄₈" hex key, remove the medallion from the end of the 

handle.

2. Replace medallion. 

3. Using the fastener removed in Step 1, attach the medallion to 

the handle. 

Adjust the Doors

■

Your refrigerator has two adjustable, front leveling screws – 
one on each side of the refrigerator base. If your refrigerator 
seems unsteady or you want the door to close easier, use the 
instructions below.

■

Before moving the refrigerator, raise the leveling screws so 
the front rollers are touching the floor. 

1. Remove the two screws fastening the base grille to the 

cabinet, and set the screws aside. Grasp the grille and pull it 
toward you.

2. Raise or lower the cabinet. 

Using a 

¹⁄₄" hex driver, turn the leveling screw on each side to 

raise or lower that side of the refrigerator.

NOTE: Having someone push against the top of the 
refrigerator takes some weight off the leveling screws. This 
makes it easier to turn the screws. It may take several turns of 
the leveling screw to adjust the tilt of the refrigerator.

■

To raise, turn the leveling screw clockwise.

■

To lower, turn the leveling screw counterclockwise. 

3. Open the door again to make sure that it closes as easily as 

you like. If not, tilt the refrigerator slightly more to the rear by 
turning both leveling screws clockwise. It may take several 
more turns, and you should turn both screws the same 
amount.

4. Replace the base grille.

REFRIGERATOR USE

Opening and Closing Doors

There are two refrigerator compartment doors. The doors can be 
opened and closed either separately or together.

There is a vertically-hinged seal on the left refrigerator door.

■

When the left-hand refrigerator door is opened, the hinged 
seal automatically folds inward so that it is out of the way.

■

When both doors are closed, the hinged seal automatically 
forms a seal between the two doors. 

Wine Rack

(on some models)

Under one shelf, there are brackets installed to the supports (one 
bracket on each support). The wine rack rests in these brackets. 

1. Remove the wine rack by lifting it up off the brackets. Press 

the right-hand side of the rack inward until it is free of its 
bracket. Lower the right-hand side slightly and disengage the 
left-hand side from its bracket. 

A

B