KitchenAid 20.8 Cu. Ft. 36" Width Built In Panel Ready French Door Refrigerator インストールガイド

5. Replace the top grille in the cabinet side trims and pull the 

panel down slightly to lock it into place.

Adjust Door(s)

1. Loosen, but do not remove, the four Torx

®† 

27 flat-head 

mounting screws. Remove the 

¹⁄₄" hex-head mounting screws 

in the top hinge.

2. Adjust the top hinge of the door to align it.

3. Tighten the Torx

®†

 27 flat-head mounting screws to a torque 

of approximately 100 inch-pounds (11.3 Nm).

4. Discard the 

¹⁄₄" hex-head screws. 

Use the following steps to adjust the door height, up or down, 
after the refrigerator has been leveled.

NOTE: Adjust the right-hand door to the position of the left-hand 
door first. If it is necessary to adjust the left-hand door, you must 
make sure that the hinged center rail located on the left-hand 
door does not drag when closing the door.

1. Open the freezer drawer. Remove the locking plate screw 

from the bottom side of the refrigerator door hinge using 
a 

¹⁄₄" open-end wrench.

2. Remove the locking plate as shown.

3. Turn the bushing located underneath the bottom of the hinge 

using a 

¹⁄₂" open-end wrench. Turning the bushing to the left 

will lower the door. Turning the bushing right will raise the 
door.

4. After adjusting, check the doors to make sure they are even 

at the top and bottom. If the doors are not even, continue to 
turn the bushing to adjust the door.

5. Replace the locking plate.

■

Turn the bushing slightly to align the hinge and locking 
plate screw holes.

■

Replace and tighten the locking plate screw.

6. Make final check to make sure the doors are aligned and 

even.

¹⁄₄

"

B

B

A

†®TORX is a registered trademark of Saturn Fasteners, Inc.

A

B

B

C

A