Netgear FS728TS - ProSAFE 24 Port 10/100 Stackable Smart Switch with 4 Gigabit Ports ハードウェアマニュアル

Installation

2-34

NETGEAR Smart Switch does not have an ON/OFF switch. The method of applying or removing 
AC power is by connecting or disconnecting the power cord. Before connecting the power cord, 
select a grounded  3-pronged AC source that is not controlled by a wall switch, which can turn off 
power to the switch. After selecting an appropriate AC source, use the following procedure to 
apply AC power.

1. Connect the female end of the supplied AC power adapter cable to the power receptacle on the 

back of the switch.

2. Connect the 3-pronged end of the AC power adapter cable to the 3-pronged AC source.

When applying power, the Power LED on the switch’s front panel is green.

If the Power LED does light up, check that the power cable is plugged in correctly and that the 
power source is functioning correctly. If this does not resolve the problem, refer to Appendix A -  

The NETGEAR Smart Switch contains software for viewing, changing, and monitoring the way it 
works. This management software is not required for the switch to work. You can use the ports  
without using the management software. However, the management software enables you to setup 
VLAN and Trunking features, and also improves the efficiency of the switch, which results in the 
improvement of its overall performance as well as the performance of the network. 

After powering up the switch for the first time, you can configure the Smart Switch using a Web 
browser or a utility program called SmartWizard Discovery. For more information about managing 
the switch, see the Software Manual on the Smart Switch Resource CD.

Note: When the device powers up, there is a default IP address already configured on the 

device. The default IP address is 192.168.0.239 and subnet mask 255.255.255.0.