KitchenAid 22.7 Cu. Ft. Counter Depth Side-by-Side Refrigerator with Exterior Ice and Water インストールガイド

The Produce Preserver pouches should be installed in their 

housing, which is located along an interior side wall of the crisper 

or convertible drawer. 

 For best performance, always use two pouches.

Remove the Produce Preserver pouches from their packaging.

Lift up on the housing in order to remove it from its mounting 

tab along the wall.

Open the housing by pulling up and out on the back of the top 

of the housing.

Place both pouches inside the housing, then snap the housing 

back together.

Place the housing back on the mounting tab along the wall.

The Produce Preserver comes with a status indicator, which 

should be activated and installed at the same time the pouch is 

installed. 

Place the indicator face-down on a firm, flat surface.

Apply pressure to the bubble on the back of the indicator, until 

the bubble pops to activate the indicator.

Slide open the cap on the Produce Preserver housing.

Place the indicator in the top of the housing, facing outward.

Slide the cap closed, and check that the indicator is visible 

through the rectangular hole in the cap.
NOTE:

 The cap will not easily close if the indicator’s rear 

bubble has not been popped.

The disposable pouches should be replaced every 6 months, 

when the status indicator has completely changed from white to 

red. 
To order replacements, see “Accessories” in the User Instructions 

or User Guide. 
1.

Remove the old pouches from the Produce Preserver housing.

Remove the old status indicator.

Install the new pouches and status indicator using the 

instructions in the previous sections.

The water filter status light will help you know when to change 

your water filter. See “Water Filtration System” in the User 

Instructions or User Guide.
NOTE: 

If water flow to your water dispenser or ice maker 

decreases noticeably, change the filter sooner. The filter should be 

replaced at least every 6 months, depending on your water quality 

and usage.  

Locate the water filter in the top-right corner of the refrigerator 

compartment.

Lift open the filter cover door. The filter will be released and 

then be ejected as the door is opened.

When the door is completely open, pull the filter straight out.
NOTE: 

There may be some water in the filter. Some spilling 

may occur. Use a towel to wipe up any spills.

Take the new filter out of its packaging and remove the cap. 

Be sure the O-rings are still in place after the cap is removed.  

With the arrow pointing up, align the new filter with the filter 

housing and slide it into place. The filter cover door will 

automatically begin to close as the new filter is inserted.

MAY IRRITATE EYES AND SKIN. DANGEROUS FUMES 
FORM WHEN MIXED WITH OTHER PRODUCTS.

Do not mix with cleaning products containing ammonia, 
bleach or acids. Do not get in eyes, on skin or clothing. Do 
not breathe dust. Keep out of reach of children.

FIRST AID TREATMENT: Contains potassium 
permanganate. If swallowed, call a Poison Control Center or 
doctor immediately. Do not induce vomiting. If in eyes, rinse 
with water for 15 minutes. If on skin, rinse with water.

CA

UTION

IR

R

IT

A

N

T

Read cautions on bac

k.

A

TTENTION

IR

R

IT

A

N

T

Lisez des pr

udences sur le re

v

e

rs

.

Do not use with water that is microbiologically unsafe or 
of unknown quality without adequate disinfection before 
or after the system. Systems certified for cyst reduction 
may be used on disinfected waters that may contain 
filterable cysts.

B

B

A