Xerox CopyCentre 265/275 ユーザーガイド
Page 4-4
Quick Reference Guide
Output
Output is used to select the finishing requirements for the job. The options will
depend on the finishing output device installed.
depend on the finishing output device installed.
HINT: For an explanation of all the finishing devices available refer to “Finishing
Devices” on page 2-14.
Devices” on page 2-14.
Options:
Collated
Select Collated for output stacked in sets to match the sequence of the originals.
Uncollated
Select Uncollated for output sorted into stacks of individual pages.
Hole Punching
This option is available if your machine is equipped with a finisher and 2 Hole Punch
or 3 Hole Punch. Each sheet is drilled individually, so there is no limit to the number
of sheets in the set. Additional Hole Punch kits can be purchased as an option. Only
one Hole Punch kit can be fitted at one time.
or 3 Hole Punch. Each sheet is drilled individually, so there is no limit to the number
of sheets in the set. Additional Hole Punch kits can be purchased as an option. Only
one Hole Punch kit can be fitted at one time.
Hole punching can only be selected for 8.5 x 11" long edge feed and 11 x
17"paper.
17"paper.
NOTE: Some stapling options can be used in conjunction with Hole Punching.
Stapling
The Stapling options are as follows:
No Staples
The output will not be stapled.
Single Staple
Use this option to add a single staple to your output.
Double Staple
Use this option to add 2 staples to your output. Staples can be added to the
Left Edge or Right Edge of your output.
This option is not available on the Basic Office Finisher.
Left Edge or Right Edge of your output.
This option is not available on the Basic Office Finisher.