Fujifilm FinePix XP90 オーナーマニュアル

For Your Safety

•  Do not mix old and new batteries, batteries

with different charge levels, or batteries of
different types.

•  If  the  camera  will  not  be  used  for  an

extended  period,  remove  the  batteries.
Note that the camera clock will be reset.

•  The  batteries  may  be  warm  to  the  touch

immediately  after  use.    Turn  the  camera
off  and  allow  the  batteries  to  cool  before
handling.

•  Battery  capacity  tends  to  decrease  at  low

temperatures.    Keep  spare  batteries  in  a
pocket or other warm place and exchange
as  necessary.    Cold  batteries  may  recover
some of their charge when warmed.

•  Fingerprints and other stains on the battery

terminals  can  impair  battery  performance.
Thoroughly  clean  the  terminals  with  a
soft, dry cloth before inserting them in the
camera.

If the batteries leak, clean the battery
compartment  thoroughly  before
inserting new batteries.

If  fluid  from  the  battery  comes  into
contact  with  skin  or  clothing,  flush
the affected area with water. If fluid 

medical attention. Do not rub your eyes.

result in permanent visual impairment.

■

The  capacity  of  Ni-MH  batteries  may  be
temporarily  reduced  when  new,  after  long
periods  of  disuse,  or  if  they  are  repeatedly
recharged  before  being  fully  discharged.
This  is  normal  and  does  not  indicate  a
malfunction.    Capacity  can  be  increased  by
repeatedly  discharging  the  batteries  using
the  discharge  option  in  the  camera  setup
menu  and  recharging  them  using  a  battery
charger.

Q

CAUTION: Do not use the discharge option
with alkaline batteries.

The camera draws a small amount of current
even  when  off.    Ni-MH  batteries  that  have
been  left  in  the  camera  for  an  extended
period  may  be  drawn  down  to  the  point
that  they  no  longer  hold  a  charge.    Battery
performance  may  also  drop  if  the  batteries
are run down in a device such as a flashlight.
Use the discharge option in the camera setup
menu to discharge Ni-MH batteries. Batteries
that  no  longer  hold  a  charge  even  after
repeatedly  being  discharged  and  recharged
have reached the end of their service life and
must be replaced.

Ni-MH batteries can be recharged in a battery
charger  (sold  separately).    Batteries  may
become  warm  to  the  touch  after  charging.
Refer  to  the  instructions  provided  with
the  charger  for  more  information.    Use  the
charger with compatible batteries only.

Ni-MH  batteries  gradually  lose  their  charge
when not in use.

■

CAUTION: Dispose of used batteries in accord
with local regulations.

This section applies to all camera models.
Use  only  FUJIFILM  AC  power  adapters
designated  for  use  with  this  camera.    Other
adapters could damage the camera.
•  The AC power adapter is for indoor use only.
•  Be sure the DC plug is securely connected

to the camera.

•  Turn  the  camera  off  before  disconnecting

the adapter. Disconnect the adapter by the
plug, not the cable.

•  Do not use with other devices.
•  Do not disassemble.
•  Do not expose to high heat and humidity.
•  Do not subject to strong physical shocks.
•  The adapter may hum or become hot to the

touch during use. This is normal.

•  If  the  adapter  causes  radio  interference,

reorient or relocate the receiving antenna.