husky-liners 54251 ユーザーズマニュアル

     

                                                                                      

5425 REAR INSTRUCTIONS

Rev: 0

Tools Required:
• 

Short Phillips screwdriver

• 

1/8” Drill bit and drill

• 

Center punch and marking utensil

Package Contents:
• 

Driver & passenger side rear mud guards

• 

#10 screw (qty. 6)

• 

Washer (qty. 6)

• 

U-Clip (qty. 6)

• 

Instruction sheet

NOTE:   It may be necessary to remove the rear wheels depending on the tools being used for installation.

 Clean the mud guard location area on the rear fender of the vehicle before installation.

1.  Install a U-Clip over any existing fender hole that will contact the mud guard (Figures 1 and 2).
2.  Attach mud guard with a #10 screw through mud guard and into the U-Clip, check fit and alignment before tightening

(Figure 2).

3.  Where there is no factory fender hole, using mud guard as a template, center punch, drill 1/8” hole, and install a #10 screw

through fender at mud guard hole locations.  There should be a total of three attachment points with fasteners at location A, B
or C, and D.