Apple B2867757 ユーザーズマニュアル

17

This chapter explains likely causes of and possible solutions for copier function
problems.

This section explains the machine's main messages. If other messages appear,
follow the instructions they contain.

❒ Check the contact address and Serial No. of Machine shown in the Service

Call message (L), and then contact your service representative. If the contact
address is not shown, contact your sales representative.

❒ For messages that are not listed here, see “When You Have Problems Operat-

ing the Machine”.

Please wait.

The main power has just 
been turned on, paper 
type (plain paper/ trans-
lucent paper/ film) was 
changed, or the machine 
is otherwise getting 
ready.

Wait for the machine to fully warm-up. 

When “

Scanning originals can 

be started.

” and “

Select copy 

mode and Place original.

” are 

displayed alternately, you can make the 
settings for your copies and scan your 
originals. After the originals have been 
scanned, the machine will automatically 
start copying after it has warmed-up. 
See “Auto Start”, Copy/Document 
Server Reference.

Cannot detect 

original size.

The machine cannot detect 
the size of the original.

Manually select a paper tray without us-
ing [Auto Paper Select], and specify a re-
production ratio without using [Auto 
Reduce / Enlarge]

.

Memory is full.

The machine's memory 
is full due to scanning 
originals or performing a 
function. The number of 
originals that can be 
stored in memory de-
pends on the size of orig-
inals and function 
settings.

• When Sort is selected, press [Exit] to 

copy scanned originals, and then 
copy remaining originals.

• When the Job Preset function is se-

lected, check the number of preset 
jobs, and then try scanning the origi-
nals again.

Check paper size.

An improper paper size 
is set.

Check the settings for Reduce/ Enlarge, 
etc., and then try again.