Apple B2867757 ユーザーズマニュアル
When a Message Appears
31
3
Alert Messages
This section describes the machine Alert messages.
Message
Cause
Solution
Cannot connect
with the wireless
card. Turn the
main power switch
off, then check
the card.
IEEE 802.11b interface
unit was not inserted
when the machine was
turned on.
unit was not inserted
when the machine was
turned on.
Turn off the machine and check the in-
terface unit is inserted correctly. Then,
turn the machine on again. If the mes-
sage appears again, call your service
representative.
terface unit is inserted correctly. Then,
turn the machine on again. If the mes-
sage appears again, call your service
representative.
Cannot connect
with the wireless
card. Turn the
main power switch
off, then check
the card.
IEEE 802.11b interface
unit was pulled out after
the machine turned on.
unit was pulled out after
the machine turned on.
Turn off the machine and check the in-
terface unit is inserted correctly. Then,
turn the machine on again. If the mes-
sage appears again, call your service
representative.
terface unit is inserted correctly. Then,
turn the machine on again. If the mes-
sage appears again, call your service
representative.
Problems with the
wireless card.
A wireless card that the
machine cannot use has
been installed.
machine cannot use has
been installed.
Turn off the machine and check the in-
terface unit is inserted correctly. Then,
turn the machine on again. If the mes-
sage appears again, call your service
representative.
terface unit is inserted correctly. Then,
turn the machine on again. If the mes-
sage appears again, call your service
representative.
Problems with the
wireless board.
Access to the wireless
board in which the IEEE
802.11b interface unit is
inserted is possible, but
an error was detected.
board in which the IEEE
802.11b interface unit is
inserted is possible, but
an error was detected.
Turn off the machine and check the in-
terface unit is inserted correctly. Then,
turn the machine on again. If the mes-
sage appears again, call your service
representative.
terface unit is inserted correctly. Then,
turn the machine on again. If the mes-
sage appears again, call your service
representative.
Problem with Hard
Disk.
An error has occurred in
the hard disk drive.
the hard disk drive.
Turn off the main power switch, and back
on again. If the message appears again,
contact your service representative.
on again. If the message appears again,
contact your service representative.
The entered pass-
word is incor-
rect.
The password of the en-
crypted PDF file has
been entered incorrectly.
crypted PDF file has
been entered incorrectly.
Enter the correct password.
Error has oc-
curred.
A syntax error, etc., has
occurred.
occurred.
Check the PDF file is not corrupted.
USB has a prob-
lem.
An error has occurred in
the USB interface.
the USB interface.
Turn off the main power switch, and back
on again. If the message appears again,
contact your service representative.
on again. If the message appears again,
contact your service representative.
Hardware Problem:
Ethernet
An error has occurred in
the Ethernet board.
the Ethernet board.
Turn off the main power switch, and back
on again. If the message appears again,
contact your service representative.
on again. If the message appears again,
contact your service representative.
Printing privi-
leges have not
been set for this
document.
You tried to print a print-
protected document.
protected document.
You cannot print this document.