Juniper CBL-M40-PWR-EU ユーザーズマニュアル
Maintain and Replace Cables and Connectors
Replace Cables and Wire Connecting to Routing Engine Interface Ports
187
Figure 89: Management Port Ethernet Connector
Replace the Console or Auxiliary Cable
The cable that plugs into the port labeled
CONSOLE
on the craft interface connects the
Routing Engine to a system console. The cable that plugs into the port labeled
AUXILIARY
connects the Routing Engine to a laptop, modem, or other auxiliary device (see Figure 88).
Both ports accept an RS-232 (EIA-232) serial cable with DB-9/DB-9 connectors. One such
cable is provided with the router, as detailed in “Routing Engine Interface Cable and Wire
Specifications” on page 52. If you want to connect devices to both ports, you must supply
another cable.
Both ports accept an RS-232 (EIA-232) serial cable with DB-9/DB-9 connectors. One such
cable is provided with the router, as detailed in “Routing Engine Interface Cable and Wire
Specifications” on page 52. If you want to connect devices to both ports, you must supply
another cable.
To replace the cable connecting to a management console or auxiliary device, follow this
procedure:
procedure:
1.
If a cable is already installed in the
CONSOLE
or
AUXILIARY
port, perform the following
steps:
a.
Turn off the power to the console or auxiliary device.
b.
Unscrew the screws that secure the cable connector to the port, using a 2.5-mm
flat-blade screwdriver if necessary. Figure 90 shows the cable connector.
flat-blade screwdriver if necessary. Figure 90 shows the cable connector.
c.
Pull the cable connector straight out of the port.
d.
Disconnect the cable from the console or auxiliary device.
2.
Plug the female end of the replacement serial cable into the
CONSOLE
or
AUXILIARY
port
and the other end into the device.
3.
Tighten the screws on the connectors at both ends, using a 2.5-mm flat-blade
screwdriver if necessary.
screwdriver if necessary.
4.
Power on the auxiliary or console device.
Figure 90: Console and Auxiliary Serial Port Connector
1063
1027