avolites pearl exper ttitan ユーザーズマニュアル

Page 100 – 8. Cue Lists

 

 

 

 

PearlExpertTitan_Man_v3.doc  29/03/2010 13:28:00 

  

[Release Mask] lets you specify using the softkeys which attributes 

will be released to their default state when the playback is killed. You 

can also use the Attribute Bank buttons on the right side of the 

console to set the mask. The default setting is to not release any 

attributes. 

This option sets how the cue list fader behaves. If set to [Fader Mode 

Intensity Kill With Off], the fader masters the overall HTP level and 

the cue list remains active (connected) even when the fader is 

lowered to zero. If set to [Fader Mode Intensity Kill At 0], the fader 

masters the overall HTP level and the cue list is killed when the fader 

is lowered to zero. If set to [Manual Crossfader] the fader behaves as 

a manual crossfade control, and the cue list will automatically step on 

to the next cue when the fader reaches the top or bottom of travel. 

This option allows you to lock the playback on a handle so that it 

always appears on that handle no matter what page is selected. 
If you select “Transparent Lock” then the playback will appear on the 

current page if no other playback is programmed in that position. 

This option allows you to change settings for each cue in the cue list. 

To select the cue number to edit, press softkey A then enter the cue 

number on the numeric keypad. 

• 

[Curve] allows you to set a different fade curve for the cue; this 

affects how the fade progresses from one cue to the other (for 

example you can select a fade which starts off slow, speeds up 

in the middle and then slows down at the end). Press H then 

select a new curve from the softkeys. The effect of the various 

• 

[Link] can be set to Press Go, With Previous Cue or After 

Previous Cue. See section 8.6.2 on page 96.  

• 

[Preload] allows you to make this cue load the LTP values from 

the next cue within the cue list (for example to pre-position 

some fixtures for an effect). 

• 

[Legend] allows you to set a legend for the cue which is 

displayed on the cue list display.  

• 

[Notes=] lets you enter a note for the cue (“Leaves stage 

pursued by bear” or “wake up spot operator”). 

This option allows you to automatically load a playback with a cue 

and is described in section 8.1.3 on page 91.