avolites pearl exper ttitan ユーザーズマニュアル
Copyright Avolites Limited 2010
3. Controlling dimmers and fixtures - Page 43
PearlExpertTitan_Man_v3.doc 29/03/2010 13:28:00
•
If the wheel display shows an arrow,
this means that there are more than
two attributes to control. Press the
Attribute button again to toggle through
the attributes.
•
You can directly control the intensity of the fixture/dimmer
using the fader of the handle.
•
The wheels operate in an “acceleration” mode. If you spin the
wheel fast, the fixture changes in larger steps. If you move the
wheel slowly, the fixture moves in its smallest increment.
•
Holding down the Avo button while turning a wheel puts the
wheel into “Fast” mode. When in this mode, a single rotation of
the wheel changes the attribute you are controlling over its full
range. For example, if while moving the Pan wheel you hold
down shift the fixture will make a complete pan movement
between end stops in one rotation of the wheel.
•
You can view the available settings (Gobo names, etc) of the
wheels on the Attribute Editor window by selecting View, [Show
workspace window], [Attribute Editor].
•
Some LED colour mixing fixtures have a Virtual Dimmer
function (using the Intensity wheel) which offers intensity
control by mastering the RGB levels when the fixture itself does
not provide an intensity channel.
3.1.5
Setting attributes using the Touch Wing
When the Touch Wing is connected, the Pearl uses the three wheels
on the Wing to set attributes rather than the wheels on the console
itself.
The touch display above
The touch display above
the wheels shows the
attribute bank (Intensity,
Position, Colour and so
on) and the current
values on the wheels.
Touch the attribute bank
Touch the attribute bank
buttons to change to a
different bank. You can
also use the attribute
bank buttons down the
right hand side of the
console as usual. The
current attribute bank is
shown with a grey
background.
If attributes have been modified, the attribute button has a pale blue
If attributes have been modified, the attribute button has a pale blue
highlight.
The Roller display shows the attributes available on each wheel.
The Roller display shows the attributes available on each wheel.
These may be shown as a percentage value, or named values for
attributes with fixed positions such as a colour wheel. If the attribute
has been modified, the current value in the programmer is
highlighted in blue.
You can touch the roller image to change the attribute value up or
You can touch the roller image to change the attribute value up or
Touch here to open
attribute editor
Touch here to change
attribute bank
Touch here to change attribute
values up and down