Hitachi VM-E520A ユーザーズマニュアル

Advanced Techniques 

- 42 - 

previously recorded tape in the camcorder. 
Remote Control Audio/Video Dubbing Buttons 
1. Connect your camcorder to the television, following "Connecting to a Television with Audio In and Video In 
Jacks" on page 28. 
2. Turn on your television and place it in the camcorder input mode (consult your television manual for details). 
3. Hold down the red button on the CAM/OFF/VIDEO switch while sliding the switch to VIDEO. 
4. Insert a previously recorded tape in the camcorder. 
5. Use the wireless remote control and press the PLAY button. Use the PLAY, F.FWD, and REW buttons to find 
the place where you want to stop dubbing. Press the PAUSE (START/STOP) button. 
6. Display the linear timer counter with memory ("Using Memory," p.41). Press the COUNTER RESET button to 
set the linear time counter to 0:00:00M. 
7. Use the REW and PLAY buttons to find where you wish to start dubbing. Press the PAUSE (START/STOP) 
button. 
8. Press and hold the A/V DUB button while pressing the PLAY button. This places the camcorder in A/V DUB 
pause mode. 
9. Press the PAUSE (START/STOP) button. The audio/video dubbing starts. When the linear time counter 
reaches 0:00:00M the camcorder stops automatically, recording only the portion of the tape that you selected. 

Note: If the camcorder is in AV DUB pause or STILL mode for more than 5 minutes, the camcorder stops 
automatically to protect the tape. 
Note: Automatic date recording is disabled during audio/video dubbing. 
Note: When the audio/video dubbed portion is played back, noise may appear at the end of the dubbed 
portion. 

If your television or VCR has AUDIO OUT and VIDEO OUT jacks you can record television programs with your 
camcorder. 
Recording Television Programs Illustration 
1. Connect the optional AV input cable to the VIDEO OUT and AUDIO OUT jacks of your television or VCR. 
2. Connect the free plug to the AV IN/OUT jack of your camcorder. 
3. Connect the camcorder to a power source. 
4. Insert a cassette in the camcorder. 
5. Hold down the red button on the CAM/OFF/VIDEO switch while sliding the switch to CAM. 
6. Turn your television or VCR on and tune it to the channel you wish to record from. 
7. Press the Start/Stop button to start recording the program that is on the screen of the television. 
8. Press the Start/Stop button again to stop recording. 

 

Note: If the tape is played back while the AV input cable is left connected to the camcorder, noise may 
appear in the picture. In this event, press the STOP button to stop the camcorder, unplug the AV input cable 
and play back the tape again. 
Note: To monitor the picture being recorded, connect the AV Stereo Output Cable (provided) to the VIDEO IN 
jack of the television as shown above. 

1. To remove the lens hood, turn it counterclockwise.