honda-power-equipment harmony ii hrs216pda ユーザーズマニュアル

Blade Installation
1. Clean around the blade holder. Install the blade(s) using the bolts 

and special washers as shown [concave side of the special 
washers toward the blade(s)].

The blade bolts and washers are specially designed for the mower. 
Should you ever have to replace them, use only genuine Honda 
parts. Otherwise, a blade may become detached from the mower 
and cause serious injury.

2. Tighten the bolts with a torque wrench. Use a wooden block to stop 

the blade(s) from turning.

Blade bolt torque: 36 ~ 43 ft-lb (49 ~ 59 N·m)

If you don’t have a torque wrench, have an authorized Honda servicing 
dealer tighten the blade bolts before you use the mower. If the blade 
bolts are overtightened, they could break. If the blade bolts are not 
tightened enough, they could loosen or come out. In either case, it 
would be possible for the blade to fly off while you are operating the 
mower.

Grass Bag Cleaning
Wash the bag with a garden hose, and 
allow it to dry completely before use; a wet 
bag will clog quickly.

Grass Bag Replacement
Replace a worn or damaged bag with a 
genuine Honda bag or its equivalent.

Bag Removal
Unclip the plastic edges of the bag from the 
frame. Remove the bag from the frame.

Bag Installation
Insert the frame into the new bag. Clip the plastic edges to the frame 
as shown.