ACTiSYS ACT-IR210L ユーザーズマニュアル
The Wireless Connectivity Expert
IR210L IrDA Motherboard Adaptor
User’s Manual
Page
11
of
14
Feb. 14, 2006
Ver. 1.5.1
10)
TROUBLE SHOOTING
For help on general and miscellaneous problems you may be experiencing with your printing,
refer to the following pages for possible solutions. Look up your problem and try the solution as
following.
SYMPTOM PROBLEM
Solution
Can not establish link
(General)
(General)
1. The two IR devices are
not aligned properly.
2. Distance is too near or
far.
3. The device is inactivated.
4. The device is not
4. The device is not
installed properly.
5. BIOS setting is wrong
1. Properly align them again.
2. Move one device to a proper
2. Move one device to a proper
distance.
3. Enable the device by IR monitor.
4. Refer to Uninstallation Guide to
4. Refer to Uninstallation Guide to
remove the device, then reinstall
again.
again.
5. Correct BIOS setting.
File Transfer between
IR-equipped PDA and
ACT-IR device-attached
host computer stops
before finishing up and
an error message
appears.
IR-equipped PDA and
ACT-IR device-attached
host computer stops
before finishing up and
an error message
appears.
The infrared communication
is interfered. For example,
something blocks out the
infrared beam or the burst
of string light source, etc.
Software does not support
the IrDA controller chip on
the motherboard.
Serial port is occupied and
not available for IR
transmission.
is interfered. For example,
something blocks out the
infrared beam or the burst
of string light source, etc.
Software does not support
the IrDA controller chip on
the motherboard.
Serial port is occupied and
not available for IR
transmission.
Check to find out the source of
interference and eliminate it before
trying again.
If you were restoring data, simply
try again.
If you were doing backup
something the PDA does not reset
its flags and keeps stopping at the
same position unless you press the
RESET button once. Be very
careful. DO NOT initialize (press
ON key and RESET button at the
same time) your PDA. Otherwise
you may lose all your data.
Make proper model # selection in
the software as specified in your PC
system User’s manual.
Make sure to disconnect modem,
etc. from the serial port to make it
available for IR transmission.
interference and eliminate it before
trying again.
If you were restoring data, simply
try again.
If you were doing backup
something the PDA does not reset
its flags and keeps stopping at the
same position unless you press the
RESET button once. Be very
careful. DO NOT initialize (press
ON key and RESET button at the
same time) your PDA. Otherwise
you may lose all your data.
Make proper model # selection in
the software as specified in your PC
system User’s manual.
Make sure to disconnect modem,
etc. from the serial port to make it
available for IR transmission.
Copyright 2003-2006 ACTiSYS Corp.