McIntosh 7205thx ユーザーズマニュアル
10
Specifications
Specifications
Power Output Per Channel
200 watts into 4 ohm loads or 120 watts into 8 ohm loads
minimum sine wave continuous average power output per
channel, all channels operating.
Output Load Impedance
8 or 4 ohms
Rated Power Band
20Hz to 20,000Hz
Dynamic Headroom
1.6dB
Frequency Response
+0, -0.25dB from 20Hz to 20,000Hz
+0, -3dB from 10Hz to 100,000Hz
Total Harmonic Distortion
0.005% maximum at any power level from 250 milliwatts
to rated power per channel from 20Hz to 20,000Hz, all
channels operating.
Intermodulation Distortion
0.005% maximum if instantaneous peak output per channel
does not exceed twice the rated output with all channels
operating for any combination of frequencies from 20Hz to
20,000Hz.
Signal To Noise Ratio
113dB below rated output, (A Weighted)
Sensitivity
1 volt (2.0V at level control center detent position)
Input Impedance
10,000 ohms
Damping Factor (Wide Band)
200 @ 8 ohms
100 @ 4 ohms
Power Supply Energy Storage
215 Joules
Power Requirements
100 Volts, 50/60Hz at 1080 watts
110 Volts, 50/60Hz at 1080 watts
120 Volts, 50/60Hz at 1080 watts
220 Volts, 50/60Hz at 1080 watts
230 Volts, 50/60Hz at 1080 watts
240 Volts, 50/60Hz at 1080 watts
NOTE: Refer to the rear panel of the MC7205 for the correct
voltage
Dimensions
Front Panel: 17/1/2 inches (44.5cm) wide, 7-1/16 inches
(17.9cm) high. Depth behind front mounting panel is 21
inches (53.3cm) including clearance for connectors. Panel
clearance required in front of mounting panel is 1-1/8
inches (2.9cm).
Weight
53 pounds (24Kg) net, 72 pounds (32.7Kg) in shipping car-
ton