ONKYO dr-2000 ユーザーズマニュアル

16

16

FIRST SETUP

TV Shape

4:3LB

Thank you for your purchase of Our DVD-Video Player.

Please make a selection

for On-Screen Language and your TV shape and

press ENTER button on your remote control.

On-Screen Language

ENG

• Make sure that all the connections from pages 10 to 15 are complete (the connection to the TV is required).
• Turning on the DVD Receiver may cause a momentary power surge, which might interfere with other electrical equipment such as computers. If

this happens, use a wall outlet on a different circuit.

The DVD Receiver enters standby mode.
The STANDBY indicator lights up in red.

• To switch off the main power, press the 

 POWER

switch again.

• The buttons on the remote controller don’t operate if

the 

 POWER switch is set to OFF.

The DVD Receiver turns on.
The ON indicator lights up in orange.
At the same time, the STANDBY indicator goes off.

The first time you turn on the DVD Receiver, the FIRST
SETUP screen appears. In the FIRST SETUP screen, select
the On-Screen Language and TV Shape according to the
aspect ratio of the TV screen (see pages 54 and 55).

Press  /  to select “On-Screen Language,” then press
ENTER.

Select a language with  / , then press ENTER.

Press   to select “TV Shape,” then press ENTER.

Press  /  to select the aspect ratio of the TV screen,
then press ENTER.

Finally press SETUP.
All of your selections are set and the FIRST SETUP
screen disappears.

• To turn off the DVD Receiver, press 

 STANDBY/ON on the DVD

Receiver, or STNBY 

 on the remote controller. The DVD Receiver

enters standby mode. Be sure to set the volume to minimum before
turning off the DVD Receiver.

• You can change the above settings later with “Customizing the

Function Settings” on page 52.

↔

Press MODE DVD or MODE AUDIO.