Motorola saber rvn4002k ユーザーズマニュアル

Additional hardware will be required if it is necessary to read,  program, or align a SABER radio.
The following section provides a list of required hardware.

Only one of the two cables is required.  Choose the appropriate one for your machine.

-

Computer Interface Cable  ( 25-pin connector cable ):

#30-80369B71

-   Computer Interface Cable  ( 9-pin connector cable ): 

#30-80369B72

Radio Interface Box  ( RIB ):                         

#RLN-4008A

RIB  Power Supply:                                             #01-80357A57 (110V)

#01-80358A56 (220V)
#60-82728J01 (9V)

Programming Cable:                                             #RTK-4203A

For Alignment:  ( See items listed in your SABER Service Manual)

- Power 

Meter

- RF 

Monitor

- 

Frequency Generator   (10 Hz - 10 kHz)

- 

Battery Eliminator:                   

#RTL-4224A  

-

Portable Products Test Set:

#RTX-4005B                 

The SABER radio and the Radio Interface Box (RIB) should be connected to the computer as
described below.  Refer to Figure 4.

Figure 4. Connecting the Radio to the Computer

   15-Pin

RLN-4008

25-Pin

Radio Interface Box

DOS 3.1

RS-232 Port

512k RAM

Computer Interface Cable
P/N: 30-80369B71
or B72
To COM 1 or COM2

Program/Test Cable
RTK-4203A

640k

10

Hardware Installation