Honeywell prestige thx9421 ユーザーズマニュアル

MCR32941

CONNECT

CONNECTED

S2

S2

S1

S1

Link thermostat to the wireless network 
(if used with an EIM or TrueZONE Wireless Adapter)

Next, link all components and RedLINK

™

accessories to the wireless network.

When the thermostat is first activated, it will lead you through the steps  
necessary to define and set up your system. The steps will change depending on
the type of system and thermostat you're installing.

If non-zoned system:
•

Setup for thermostat only

•

Setup for use with EIM

If zoned system:
•

Setup for EIM wired to zone panel

•

Setup for thermostat wired to zone panel

•

Setup for RedLINK wireless connection to zone panel
(using THM4000 TrueZONE Wireless Adapter)

If non-zoned system:
•

Setup for EIM connection

If zoned system:
•

Setup for EIM wired to zone panel

•

Setup for RedLINK wireless connection to zone panel
(using THM4000 TrueZONE Wireless Adapter)

While the EIM light is flashing, press 

NEXT to link 

the thermostat with the EIM. After a brief delay, 
the screen will display "Device Connected."

Press and release the 

CONNECT button at the EIM or Wireless 

Adapter, and make sure the "Connected" light is flashing green.

If the "Connected" light does not flash, make sure no other 
RedLINK devices are in Wireless Setup mode, then try again.

Use the step-by-step thermostat menus to define your system type (above).
When you reach the Wireless Setup screen, follow the steps below:

At any screen you can press 

HELP for more information, 

or press 

BACK to change earlier options.

If the "Connected" light does not flash on the Wireless 
Adapter, consult the TrueZONE manual for help.

•

Green flashing: In Wireless Setup mode.

•

Green steady: System is working normally.

•

Red: Wireless device(s) not communicating. Check EIM and RedLINK devices.

69-2490_B.indd   5

7/13/2011   1:41:50 PM