Microtek gnc m vx2 0506 ユーザーズマニュアル

Any dirt or stains on the lens surface should be cleaned off immediately with

a piece of soft, dry cloth not made of cotton or velvet material. You may also

clean the projector by wiping gently the lens surface with a soft cloth moist-

ened with a mixture of water and a neutral detergent.

Unplug the power cord of the projector before cleaning the projector case.

Then, wipe away any dirt or stains with a soft, non-cotton or non-velvet cloth.

If the dirt or stains cannot be removed, use a cloth moistened with a mixture

of water and a neutral detergent. Do not use alcohol, benzene, thinners, or

any other chemical detergents, as these will cause damage or overheating

to the projector.

The air filter located at the bottom of the projector should be cleaned once

every 100 working days. Without regular cleaning, the projector will be

blocked by dust, and it will cause the projector to overheat due to poor

ventilation.

1.

Turn off the power and unplug the power cord.

2.

Stand the projector up with the handle at the top so that easy access

can be made to the air filter.

3.

Take off the filter cover.

4.

A small-size vacuum cleaner for computer or office use can be used

for cleaning the filter, or a piece of dry, non-cotton or non-velvet cloth

can be used in the cleaning process.

Attention: If the clogged dirt is difficult to clean away or if the filter is

old, replacement with a new filter is required. Please contact the

dealer of this projector for this part.

5.

After the filter is cleaned, put it back to the original place, and put the

filter cover on properly, making sure the screws are secured.

ＶＸ２．ｐ６５

02-10-18, 11:05

40