Cadillac 2004 escalade esv ユーザーズマニュアル
5. Turn the vertical aiming screw (V) until the
headlamp beam is aimed to the horizontal tape line.
The top edge of the cut-off should be positioned
at the bottom edge of the horizontal tape line.
The top edge of the cut-off should be positioned
at the bottom edge of the horizontal tape line.
6. Repeat Steps 4 and 5 for the opposite headlamp.
Bulb Replacement
See Replacement Bulbs on page 5-60 for the proper
type of bulbs to use.
type of bulbs to use.
For any bulb changing procedure not listed in this
section, contact your dealer.
section, contact your dealer.
High Intensity Discharge (HID)
Lighting
Lighting
{
CAUTION:
The low beam high intensity discharge lighting
system operates at a very high voltage. If you
try to service any of the system components,
you could be seriously injured. Have your
dealer or a qualified technician service them.
system operates at a very high voltage. If you
try to service any of the system components,
you could be seriously injured. Have your
dealer or a qualified technician service them.
After your vehicle’s HID headlamp bulb has been
replaced, you may notice that the beam is a slightly
different shade than it was originally. This is normal.
replaced, you may notice that the beam is a slightly
different shade than it was originally. This is normal.
5-53