honda-automobiles accessories c100 ユーザーズマニュアル

2.16 Grease the bearings. Fit one, then the distance collar and then the second bearing. Fit the oil seals. 
2.17 Fit the four 8 mm bolts and the hub into the wheel, tighten all eight wheel bolts evenly. 
2.18 Fit the brake cam and then the external operating arm. Fit the springs to the shoes, and then fit the shoes to 
the brake unit. 
2.19 Make sure that the speedometer gear is installed on the brake panel. Fit the brake into the hub, making sure 
that the tabs on the speedometer gear engage with its drive slots in the hub. 
2.20 Making sure that the side collar is fitted, fit the wheel into the forks. Make sure that the slot on the back of 
the brake panel engages with the cast peg on the left hand fork leg. 
2.21 Fit the axle spindle. Fit the washer and the axle nut. Tighten the axle nut and fit the cotter pin. 
2.22 Fit the speedometer cable. 
2.23 Fit the spring onto the brake cable, slide the pin into the external brake operating lever, and slide the brake 
cable through the hole in the oin. Fit the brake adjusting nut. 
2.24 Operate the brake a few times to make sure that the brake shoes have settled into position. Adjust the brake 
(see the Maintenance page). 
2.25 Inflate the tyre to its correct pressure. 
2.26 Give the bike a gentle road test and then recheck all the nuts etc for security and re-adjust the brake if 
required. 

  

  
  
  
  
  
  
  
  
  
  
  
  
  
  
  

To remove the front wheel and brake, see section 2.0, the front wheel and brake section.