honda-automobiles gcv190 ユーザーズマニュアル

ENGLISH

2. See equipment manual and 

position the throttle control 
so the choke/throttle lever 
moves to the CHOKE 
position (cold engine).

3. See equipment manual 

and position the flywheel 
brake control so the 
flywheel brake lever is in 
the RUN position.

4. Pull the starter grip lightly until 

resistance is felt, then pull briskly.

5. If the choke was used to start the 

engine, move the choke/throttle 
lever to the FAST (or high) position 
as soon as the engine warms up 
enough to run smoothly without 
use of the choke.

Throttle Setting
Position the throttle control for the desired engine speed. For best 
engine performance, it is recommended the engine be operated with 
the throttle in the FAST (or high) position.

Stopping The Engine
1. Move the choke/throttle control to 

the SLOW position.

2. Release the flywheel 

brake lever to stop the 
engine.

3. Turn the fuel valve to 

the OFF position (see 
TYPE 1 Step 1 on 
page 2).

Starting The Engine
1. Turn the fuel valve to the ON position (see TYPE 1 Step 1 on 

2. Move the choke lever to the ON position (cold engine).

3. Move the throttle lever to the FAST position.

4. Pull the starter grip lightly until resistance is felt, then pull briskly 

(see TYPE 1 Step 4 on page 3).

5. If the choke was used to start the engine, move the choke lever to 

the OFF position as soon as the engine warms up enough to run 
smoothly without use of the choke.

6. Position the throttle lever for the desired engine speed. For best 

engine performance, it is recommended the engine be operated 
with the throttle in the FAST (or high) position.

Stopping The Engine
1. Move the throttle lever to the SLOW position and allow the engine 

to idle for a few seconds.

2. Move the throttle lever to the STOP position.

3. Turn the fuel valve to the OFF position (see TYPE 1 Step 1 on 

Starting The Engine
1. Turn the fuel valve to the 

ON position (see TYPE 1 
Step 1 on page 2).

2. Move the choke control 

cable (see equipment 
manual) so that the choke 
arm moves to the choke 
ON position (cold engine).

3. Move the flywheel brake lever 

to the RUN position.

4. Pull the starter grip lightly until 

resistance is felt, then pull 
briskly (see TYPE 1 Step 4 on 
page 3).

5. If the choke was used to start 

the engine, move the choke 
control cable so that the choke 
arm moves to the OFF position 
as soon as the engine warms 
up enough to run smoothly without use of the choke.

The engine speed is preset on this type.

Stopping The Engine
1. Release the flywheel brake lever to stop the engine.

2. Turn the fuel valve to the OFF position (see TYPE 1 Step 1 on 

POM52684-L.book  Page 3  Monday, February 5, 2007  3:00 PM