Haier xqb60-91bf ユーザーズマニュアル
English
3. Install the drain hose to the side of the washer using drain hose clamp. The drain
hose must be placed into a drainpipe or sink at least 1
1/2
inches in diameter.
Use the gooseneck to hold hose in place. To avoid possible water back up, the
drain hose must reach height of at least 31
drain hose must reach height of at least 31
1/2
inches minimum and 40 inches
maximum.
Note:
“Y Adaptor” shown in above figure is only for illustration. It is not provided
in the box as an accessory. If you need to utilize this type of hookup, you can
purchase a “Y Adaptor” from your nearest hardware store.
purchase a “Y Adaptor” from your nearest hardware store.
4. Plug in the Washer to a regular 115 Volt / 60 Hz, 15 Amps outlet.
Note:
Inspect carefully for any leaks around and back of the machine. If there is a
leak then double check to see if any connections are loose. You may need to
tighten loose connections.
leak then double check to see if any connections are loose. You may need to
tighten loose connections.
CAUTION:
If after completing these steps, you are unsure that unit is properly
installed, contact a qualified installer. To ensure that your Washer is
properly installed it is recommended that it be installed by a certified
installer.
installed, contact a qualified installer. To ensure that your Washer is
properly installed it is recommended that it be installed by a certified
installer.
Water Supply Hose
Drain Hose
Goose Neck
Water Inlet
Hose Bend
SINK
“Y” Adapter
25
XQB60-91BF MANUAL 10/22/01 11:42 AM Page 26