Jacuzzi fuzion bath series 7260 ユーザーズマニュアル
ENGLISH
Important: Read complete instructions before beginning installation.
Each Fuzion whirlpool bath arrives completely equipped with motor/pump assembly, heater, and plumbing neces-
sary for whirlpool operation. Before tub installation can begin, install overflow fitting and pull control panel cord
through control cutout in the tub deck. If unit is equiped with wood frame set frame aside in protective packaging until
final trim installation.
through control cutout in the tub deck. If unit is equiped with wood frame set frame aside in protective packaging until
final trim installation.
Remove the bath from the carton. Retain the shipping carton until satisfactory inspection of the product has been
made. Do not lift the bath by the plumbing at any time; handle by the shell only.
Immediately upon receipt, inspect the shell and tub contents before installing. Should inspection reveal any dam-
age or defect in the finish, do not install the bath. Damage or defect to the finish claimed after the bath is installed is
excluded from the warranty. Jacuzzi Whirlpool Bath's responsibility for shipping damage ceases upon delivery of the
products in good order to the carrier. Refer any claims for damage to the carrier. For definitions of warranty coverage
and limitations, refer to the published warranty information packed with the product or in the back of this manual.
excluded from the warranty. Jacuzzi Whirlpool Bath's responsibility for shipping damage ceases upon delivery of the
products in good order to the carrier. Refer any claims for damage to the carrier. For definitions of warranty coverage
and limitations, refer to the published warranty information packed with the product or in the back of this manual.
All bath units are factory tested for proper operation and watertight connections prior to shipping. NOTE: Prior to
installation, the bath must be filled with water and operated to check for leaks that may have resulted from
shipping damage or mishandling. Jacuzzi Whirlpool Bath is not responsible for any defect that could have been
discovered, repaired, or avoided by following this inspection and testing procedure.
shipping damage or mishandling. Jacuzzi Whirlpool Bath is not responsible for any defect that could have been
discovered, repaired, or avoided by following this inspection and testing procedure.
INSTRUCTIONS
5
Jacuzzi Whirlpool Bath DE99000A 3/06
This manual is intended to assist you with the installation of your Fuzion tub.
Specifications for all tubs are combined.
Framing and Support installation instructions are divided into two sections;
Framing and Support installation instructions are divided into two sections;
drop-in and undermount.
The remaining instructions for all tubs are combined.
(Motor)
(Heater)
SIDE VIEW
END VIEW
L
H
W
6-1/4" (159 mm)
FUZION 7260 WITH WOOD FRAME SINGLE MOTOR
(Motor 1)
(Heater)
SIDE VIEW
END VIEW
L
H
W
5" (127 mm)
FUZION 7260 UNDERMOUNT SINGLE MOTOR
SIDE VIEW
END VIEW
END VIEW
(Motor 1)
(Heater 1 & 2)
(Motor 2)
L
H
W
5" (127 mm)
FUZION 7260 UNDERMOUNT DUAL MOTOR
SIDE VIEW
END VIEW
END VIEW
(Motor 1)
(Heater 1 & 2)
(Motor 2)
L
H
W
6-1/4" (159 mm)
FUZION 7260 WITH WOOD FRAME DUAL MOTOR
DRAIN/OVERFLOW
B
A
B
A
Undermount
With Wood Frame
RECTANGULAR
SPECIFICATIONS
SIDE VIEW
(Motor)
(Heater)
END VIEW
H
W
L
(133 mm)
5-1/4"
FUZION 7236 WITH WOOD FRAME
SIDE VIEW
L
(Motor)
(Heater)
END VIEW
H
W
(102 mm)
4"
FUZION 7236 UNDERMOUNT