Jacuzzi ProTech LCD ユーザーズマニュアル

Page 30

The control system remembers the time of day even in the event of a 
prolonged power outage. However, it may occasionally be necessary to reset
the time of day. For example: if you are not in the Pacific Time Zone you will
want to reset the time for your own time zone. (The system will automatical-
ly adjust to and from daylight savings time.)  To accomplish this, press DIS-
PLAY, MODE and DISPLAY within five seconds each. A number represent-
ing the hour will be displayed, followed by AM or PM. The hour will advance
or decrease each time WARMER ( + ) or COOLER ( - ) is pressed within five
seconds. Then, press DISPLAY again to display the minutes. Adjust the min-
utes as necessary by pressing WARMER ( + ) or COOLER ( - ) After 5 sec-
onds, the display will return to normal.

The control system allows you to easily adjust two separate aspects of each
of the skimming/heatng cycle: 1) the time of day at which each cycle begins;
and 2) the duration of each cycle. 

To  make adjustments, first press CYCLE to  enter the skimming/heating cycle
programming mode. The LCD screen will display the following in the upper right
corner:

This means the system is ready to accept your changes to the start time for
skimming/heating cycle number one. Simultaneously, the large four-digit 
display in the center of the screen displays the currently programmed start
time for that cycle.

At this point, you have four options. You may:
1.

Press WARMER ( + ) or COOLER ( - ) to adjust the start time in incre-
ments of 30 minutes.

2. Press  CYCLE  to  display and adjust each subsequent skimming/heating

cycle start time. With each press, the currently programmed status will be
shown in the large four digit display. To adjust any display value, simply
press WARMER ( + ) or COOLER ( - ).

3. Press SELECT to move down the menu from Start Time to Duration.