eutech-instruments alpha con 1000 conductivity controllertransmitter ユーザーズマニュアル

Operating Instructions

α

lpha-CON1000

68X216802

23

1) Follow directions in 7.9.2 to enter Configuration mode.
2) Press the ENTER key. Scroll with the 

∆∆

 or 

∇

∇

 keys until the upper

display shows “Stdy” or “FLEt” and lower display shows “AL.C.”.
- 

AL.C = alarm contact

- 

StdY = steady contact

- 

FLEt = fleeting (single pulse) contact

3) Press the 

∆∆

∇

∇

 keys to select steady or pulse contact.

4) Press the ENTER key to confirm your selection.
5) Proceed to 7.9.4, or return to Measurement mode by pressing the

∆∆

 and 

∇

∇

 keys simultaneously (escape).

7.7.4 Input Line Resistance Adjust
This function compensates for the line resistance of the cable to its cell.  

1) Follow directions in 7.9.3 to enter Configuration mode.
2) Press the ENTER key. Scroll with the 

∆∆

 or 

∇

∇

 keys until the

upper display shows “0.0” and lower display shows “L.Ad”.
- 

L.Ad = line adjuster resistance (0.0 to 100.0)

3) Press the 

∆∆

∇

∇

 keys to input the value.

4) Press the ENTER key to confirm your selection.

5) Proceed to 7.9.5, or return to Measurement mode by pressing the 

∆∆

 and 

∇

∇

 keys simultaneously

(escape).

7.7.5 Reverting to factory default settings
Use this parameter to reset all settings to factory default. Changing from “no” to “YES” and pressing the

ENTER key resets all settings to factory default.

overwritten as a result!
1) Follow directions in 7.9.4 to enter Configuration mode.
2) Press the ENTER key. Scroll with the 

∆∆

 or 

∇

∇

 keys until the upper

display shows “no” or “YES”, and the lower display shows “deF”

(default).

3) Press the 

∆∆

∇

∇

 keys to select no or yes. Selecting “YES” and pressing the ENTER key will

overwrite all setting you have made and automatically return you to Measurement mode.

4) Press the ENTER key to confirm your selection and to return to Advanced Set-up mode, or return

to Measurement mode by pressing the 

∆∆

 and 

∇

∇

 keys simultaneously (escape).

The calibration procedure in Advanced Set-up mode is identical to the procedure in the Calibration

mode. The only difference is that the controller will revert back to Set-up mode (instead of Measurement

mode) after calibration is completed.

no

no

dEF

dEF

HOLD  SETUP

0.0

0.0

L.Ad

L.Ad

HOLD  SETUP

Stdy

Stdy

AL.C

AL.C

HOLD  SETUP

FLEt

FLEt

AL.C

AL.C

HOLD  SETUP