Traveler DC-5080 ユーザーガイド

Charging the Battery

Using the AC power adapter may charge the battery or operate the camera as power supply. Make sure that
the power of the camera is off and then insert the battery before starting.
1. Insert one end of the AC power adapter into the DC IN terminal of the camera.
2. Insert the other end of the AC power adapter into a wall outlet.

The status LED flashes green when charging is started and lights green when charging is completed.

It is recommended to fully discharge or exhaust the battery before being charged.

Charging time varies according to the ambient temperature and the status of battery.

Note:

This camera must be used with specified AC power adapter. Damage caused by the use of an incorrect
adapter is not covered under the warranty.

When the charging is not started even if following the above procedure, turn the power on at any mode after
LCD monitor turns on, and then turn the power off.

The battery may feel warm after it has been charged or immediately after being used. This is normal and not
a malfunction.
When using the camera in cold areas, keep the camera and battery warm by holding them inside your outer
cloth.

If you open the battery cover without removing the battery, the power will not be terminated. If you remove
the battery, you have to insert the battery again in a period of 2 hours in order to make sure that the date
and time will not be reset.

We recommend the battery should be charged 8 hours as first time use.

Danger of explosion, if the battery is not properly replaced! Only replace with the same or an equivalent
battery type (3.7V, 650mAh)!

Please note the battery disposal regulations on page 73.

We give 6 months of warranty on the supplied rechargeable batteries.