Essence Security International ltd. ES7000EG ユーザーズマニュアル
Operation
48
EverGuard Control Panel
Note: by default, every screen that is displayed from the navigation
pane contains parameters that cannot be modified until they are
enabled.
pane contains parameters that cannot be modified until they are
enabled.
3.3.2.5 CMD Tab
The CMD tab controls many of the
security commands in this single
navigation pane.
security commands in this single
navigation pane.
It is divided into the following
sections:
sections:
Security
Maintenance
Communication
Home Automation
To set the command options via the CMD tab:
1. On the Navigation pane, CMD tab, select Security, and set the Security
mode according to the desired method to secure the designated area. This is
done using remote upload.
done using remote upload.
Arm – the system is fully armed
Disarmed – the system is disarmed
Perimeter Arm – the perimeter partition is armed
2. Under Maintenance, if the Panel Info dialog box reads INCOMPLETE after a
software update attempt, force the end of a Software update. Click Force
End Installation.
End Installation.
3. To reset the Control Panel, click Reset Panel.
4. Under Communication Status, CCS is the default setting.
5. Under Communication, select one of the following three modes to change
the status in the Communication Status:
NTS
CCS
ITS