Mitel Deutschland GmbH 68635RFP36U-01 ユーザーズマニュアル
SIP-DECT OM System Manual
46
•
Incoming ringing calls which are not yet connected are converted to waiting calls.
•
If a third line is open due to a waiting call, that call is released and the line is replaced by the intercom
call.
•
Outgoing calls that have not yet been answered and are in a dialing state, are released.
•
If a call is on hold by the B party, the call is released. An on-hold by the B party is difficult to maintain
while another line has an active audio stream.
Normally, the user should be able to resume the interrupted calls again when the intercom call is
finished. However, the calls may fail if several maintained lines collide with call exceptions (e.g., a failed
call transfer that was maintained in the background).
finished. However, the calls may fail if several maintained lines collide with call exceptions (e.g., a failed
call transfer that was maintained in the background).
Please note:
Barge-in is rejected if the DECT phone is part of a SOS/alarm call.
3.35.1.2 Outgoing intercom calls
A DECT phone can initiate an intercom call. The user must dial the configured access code, followed by
the destination’s user id / number.
A DECT phone can initiate an intercom call. The user must dial the configured access code, followed by
the destination’s user id / number.
If a DECT phone generates an intercom call, an Alert-Info header is added to the SIP INVITE:
•
the “Alert-Info” header contains “<http://x>info=alert-autoanswer”
3.35.2 AUTO ANSWER AUDIO SETTINGS
You can configure global auto-answer settings through the OMM Web service or the OMP. Global
settings are valid for all DECT phone users in the system, except users who have individual settings.
settings are valid for all DECT phone users in the system, except users who have individual settings.
Incoming call settings:
•
Auto answer allowed (default: true)
•
Microphone mute (default: true)
•
Warning tone (default: true). A short ringtone is played if there are no active calls. If there is an active
call in a “barge in” situation, the ringing will be in-band.
•
Allow barge in (default: true)
Outgoing call setting:
•
Dial prefix (default: string is empty). Empty string means that an intercom call cannot be initiated by a
DECT phone.
3.35.2.1 User-specific incoming call setting
You can set user-specific settings via OMP, but not the OMM Web Service. Default values for all
parameters are inherited from global settings.
You can set user-specific settings via OMP, but not the OMM Web Service. Default values for all
parameters are inherited from global settings.