Guangzhou Chiyuan Electronic Co. Ltd. 300L ユーザーズマニュアル
R/C Introduction Manual
24
3.3 Connection between Receiver and Servos(2.4G)
2.4G Radio Data Transmission
1.Technology of FHSS 2.4G radio transmission and receiving
2.Working frequency is the worldwide universal frequency band of ISM ( Industrial
Scientific and Medical), free of charge, and the range is from 2.400 GHz to 2.483 Ghz.
3. Max transmitting power: 20dBm 100mA.
4. Max. receiving sensitivity: -93dBm.
5. Working current at transmitting end: 200mA ~ 300mA.
6. Working current at receiving end: ＜ 50mA.
7. Data transfer rate : 19200 bit/Sec.
8. Working temperature: 0º to 70ºC.
R/C Introduction Manual
3.2 Handling Procedure For Batteries
23
!
Battery Replacement
1.Remove the battery cover from the transmitter by sliding it in the direction of the arrow .
2. Remove the used batteries.
3.Load the new AA size batteries. Pay very close attention to the polarity marking and
reinsert accordingly.
4 .Slide the battery cover back onto the case.
2. Remove the used batteries.
3.Load the new AA size batteries. Pay very close attention to the polarity marking and
reinsert accordingly.
4 .Slide the battery cover back onto the case.
!
Caution
Always be sure your reinsert the batteries in the correct polarity order. If the batteries are
loaded incorrectly, the transmitter may be damaged.
When the transmitter is not used , always remember to remove the batteries. If the batteries
do happen to leak, clean the batteries case and contacts thoroughly. Make sure the contacts
are free of corrosion.
loaded incorrectly, the transmitter may be damaged.
When the transmitter is not used , always remember to remove the batteries. If the batteries
do happen to leak, clean the batteries case and contacts thoroughly. Make sure the contacts
are free of corrosion.
!
Battery Disposal
Some countries require special handling of used of batteries ,please contact the agencies
responsible for recycling hazardous wastes in your local area.
responsible for recycling hazardous wastes in your local area.
!
Battery low voltage alarm indicator.
Technology Data
TRANSMITTER
Channels: 3
Frequency: 2.4G
DC: 9.6V,≤150mA
Net weight: 360g
Channels: 3
Frequency: 2.4G
DC: 9.6V,≤150mA
Net weight: 360g
RECEIVER
Channels: 3
Frequency: 2.4G
DC: 4.5~5.5v,≤30mA
Net weight: 9.0g
Channels: 3
Frequency: 2.4G
DC: 4.5~5.5v,≤30mA
Net weight: 9.0g
ESC
+ -
SERVO3(CH3)
SERVO1(ST.)
SERVO2(TH.)
BATT.( 4.8V)
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
following two conditions (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
compliance could void the user's authority to operate the equipment.
XY3000/ XY3100/ XY300P/ XY4000/ 8183
FCC Radiation Exposure Statement
The antennas used for this transmitter must be installed to provide a separation distance of
at least 20 cm from all persons and must not be collocated or operating in conjunction with
any other antenna or transmitter.
any other antenna or transmitter.