Meshreen Technology Ltd. 69M03 ユーザーズマニュアル

DS-MS5168 / info@meshreen.com

8. Federal Communication Commission

Interference Statement

Any changes or modifications not expressly approved by the party responsible compliance could void your

authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in

a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

Notice:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference and

(2) This device must accept any interference received, including interference that may cause undesired operation.

RF Radiation Exposure Statement

1. This Transmitter must not be collocated or operating in conjunction with any other antenna or transmitter.

2. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This

equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and

your body.

As long as the above condition is met, further transmitter testing will not be required. However, the OEM integrator

is still responsible for testing their end product for any additional compliance requirements required with this

module installed (for example, digital device emissions, PC peripheral requirements, etc.). This applies to the

MS5168-M00 and MS5168-M03 devices; the MS5168-M04 and MS5168-M05 are mobile devices (see below)

High Power Module usage limitation

The high power module variants are classified as ‘mobile’ device pursuant with FCC § 2.1091 and must not be used

at a distance of < 20 cm (8”) from any people. This applies to the MS5168-M04 and MS5168-M05 module type

(

2AC2E-68M04

IMPORTANT NOTE: In the event that these conditions cannot be met (for certain configurations or co-location with

another transmitter), then the FCC authorization is no longer considered valid and the FCC ID cannot be used on

the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product