Meshreen Technology Ltd. ZSB-6801 ユーザーズマニュアル
© Meshreen
DS_ZSB-681x_1v0
5
3. Downloading Binary Code
To use the JN51xx Flash Programmer GUI to download a .bin file to the USB Module, there is no need to operate
the “Program” key as EVK since it will enter programming mode automatically, follow the procedure below.
Step 1
Plug the Module into a USB port of your PC.
Step 2
. Run the Flash programmer application by double click
“FlashGUI.exe”
Step 3
In the COM Port field of the interface, select the PC serial communications port for the board
connection– to identify the relevant port, refer to Chapter 6.
Figure 1 Flash Programmer Com Port Selection
Step 4
Enable the automatic reset and programming mode signals for the target device. To do this, in the USB
Module area of the interface, ensure that the checkbox Automatic Program and Reset is ticked (if this box
is not ticked, the target JN51xx device will not enter programming mode and the download will fail).