Ergotech Group 100-D16-B02 プリント
OCT-08
www.ergotechgroup.com
ERGOTECH GROUP, INC.
8 Westchester Plaza
Elmsford, NY 10523
9143473800
8 Westchester Plaza
Elmsford, NY 10523
9143473800
Special Interest
Articles:
Articles:
• Add a highlight
or your point of
interest here.
interest here.
• Add a highlight
or your point of
interest here.
interest here.
• Add a highlight
or your point of
interest here.
interest here.
To adjust monitors:
Laterally: Place hand on bottom of monitor and lift slightly to support weight. Monitor will slide along bar.
Laterally: Place hand on bottom of monitor and lift slightly to support weight. Monitor will slide along bar.
Left/Right and Up/Down: Grasp monitor with both hands and adjust to desired position.
To tension the vertical adjustment to the weight of monitor: Tighten the 5mm bolt on the right side of the pivot
with the hex wrench provided.
To remove monitor: Take the weight from the monitor with one hand on the bottom and tip back slightly while
using the other hand to lift the top of the silver release button. Lift up and back and this will release the monitor
from the stand.
Installation Instructions
Product # 100-D16-B02 – Dual Horizontal Desk Stand
1. Check to see that small hex set screw at rear of
base is backed out enough to allow pole to seat
down completely. Insert pole into base. Tighten set
screw.
down completely. Insert pole into base. Tighten set
screw.
2. Loosen ratchet type handle on pole clamp with
horizontal bar (ratchet handle must be on the right
side of the pole). Slide clamp and assembly over
pole and tighten handle.
side of the pole). Slide clamp and assembly over
pole and tighten handle.
3. Attach quick release pivots to back of each monitor
with screws provided. Be sure that silver release
button is toward the top of the monitor.
button is toward the top of the monitor.
4. Place each monitor on the horizontal bar by tipping
back approximately 45 degrees and then down
until the silver release button engages groove and
clicks down into place.
until the silver release button engages groove and
clicks down into place.