Makita EBH341L ユーザーズマニュアル

11

Turn the machine upside down, and you can replace the cutter blade or nylon 

cutting head easily.

–  Insert the hex wrench through the hole in the gear case and rotate the 

receiver washer (4) until it is locked with the hex wrench.

–  Loosen the nut (1) (left-hand thread) with the socket wrench and remove the 

nut (1), cup (2), and clamp washer (3).

Hex wrench

With the hex wrench still in place.
–  Mount the cutter blade onto the shaft so that the guide of the receiver washer 

(4) fits in the arbor hole in the cutter blade. Install the clamp washer (3), cup 

(2), and secure the cutter blade with the nut (1). 

[Tightening torque: 13 - 23 N-m]

NOTE:  Always wear gloves when handling the cutter blade.

NOTE:   The cutter blade-fastening nut (with spring washer) is a consumable 

part.  

If there appears any wear or deformation on the spring washer, replace 

the nut.

–  The clamp washer (3), cup (2), and nut (1) are not necessary for mounting 

the nylon cutting head. The nylon cutting head should go on top of the 

receiver washer (4).

–  Insert the hex wrench through the hole in the gear case and rotate the 

receiver washer (4) until it is locked with the hex wrench.

–  Then screw the nylon cutting head onto the shaft by turning it counter-

clockwise.

–  Remove the hex wrench.

Rotation

–  Make sure that the blade is the left way up.

(3)

(2)

(1)

Hex wrench

Loosen

Tighten

Hex wrench

(4)

(4)